Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Gate Access Control Across Providence
Gate access control in Providence means keypads, remotes, phone entry, card readers, and video intercoms on homes that are now 15 to 20 years old. Most of the systems we repair here were installed during the original master-planned buildout, and they’re failing on a schedule. Boards die. Posts lean. Safety sensors go missing. We fix it the right way, usually same day on repair calls, and Hal Gatewood’s name is on every invoice. Call (979) 291-0947 and a live person answers.
Providence Village was built fast in the early-to-mid 2000s, and the gate hardware went in just as fast. That age is showing now, all across the community. We know what the original builders installed, what parts have been discontinued, and what the HOA will and won’t approve. This is not generic gate work. It’s Providence gate work, and that’s a difference you’ll feel the first time we show up.
Why Gatewood Fence & Gate Is Providence’s Preferred Gate Access Control Company
We’ve been answering calls in Providence since the neighborhoods off Cedar Ridge Drive and Providence Boulevard were still being framed. Hal Gatewood founded the shop in 2001, and he still runs it. That’s 29 years of gates, and the same person behind the phone number. When a Providence homeowner calls with a dead LiftMaster keypad or a swing gate that won’t close after a cold snap, the person who picks up knows exactly what they’re describing.
We’re not a call center. We’re not a dispatch queue. Hal’s crew works Providence directly, and a live person answers 24/7, which matters when your gate is stuck open at 9 p.m. and your dog thinks the front yard starts at the sidewalk. Our Gate Access Control team has handled hundreds of aging operators in this community, and we’ve seen every failure mode these 2000s-era installs can throw at you.
We publish our address and license number. We background-check and uniform whoever steps onto your driveway. And every job, from a simple remote reprogram to a full video intercom retrofit, carries the 90-Day Done Right Promise in writing. If it’s not right, one call brings Hal back. No runaround.
Our Gate Access Control Services in Providence
Keypad Entry
Providence gates came with basic keypads in most cases, and those keypads are now cracked, sun-faded, and intermittently dead. We replace them with current weatherproof models, program codes on site, and test the whole loop before we leave. Expect $180 to $340 for a standard keypad replacement and reprogram.
Remote Control
Remotes fail quietly. A homeowner on Stonebridge Drive will find the gate only opens from the wall station and assume the motor died, when the real problem is a receiver board from 2006 that no longer talks to the remote. We stock common rolling-code receivers and can pair new remotes to FAAC, BFT, Linear, and Viking operators the same day. A remote reprogram or receiver swap in Providence typically runs $85 to $220 depending on the operator.
Phone Entry
Phone entry systems are becoming the standard for Providence driveways, especially for homes where the gate is 80 to 120 feet from the house and the builder never ran a hardwired intercom. We install cellular and VoIP phone entry units that call your cell phone when someone presses the button, with no monthly contract from us. Budget $450 to $950 installed for a solid phone entry system on a single gate.
Card Reader
Some Providence homeowners want a card or fob reader for a rental property, a home office entrance, or a second gate. We install and program card readers that work with your existing operator, including retrofits onto LiftMaster and FAAC openers from the 2004 through 2008 era, which is what we mostly see here. A single-proximity card reader install runs $300 to $650.
Video Intercom
This is the upgrade we recommend most often in Providence right now, because a camera at the gate does what a keypad can’t: you see who’s there before you open. We install video intercoms with phone app access, night vision, and two-way audio, wired into your existing gate operator. A turnkey video intercom on a Providence driveway gate runs $800 to $1,600 installed, depending on wiring distance and whether we need to trench new low-voltage line.
Smart Access
Smart access means controlling your gate from your phone, setting schedules, and getting alerts when the gate cycles. Most older Providence operators can be retrofitted with a smart control module without replacing the whole opener. We’ll tell you honestly if your 2005 LiftMaster board is worth retrofitting or if you’re throwing good money at a motor that’s already on borrowed time. Smart module installation typically runs $250 to $400 on top of the base repair.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Providence
We’re certified to service nine major gate brands, but the ones we see most on Providence driveway gates are FAAC, BFT, Linear, and Viking. Those four came standard on a lot of the original master-planned packages. We keep common boards, safety photocells, and remotes for them on hand so we aren’t waiting on a parts truck when your gate is down. If your operator is something else entirely, we can usually source it within a day or two, and we’ll weld or fabricate adapters on site when the original mounting brackets are long discontinued.
Common Gate Access Control Problems We See in Providence Homes
- Obsolete control boards dying without warning. The LiftMaster and FAAC models installed here in the early 2000s are now 15 to 20 years old, and their boards are reaching end of life all at once. One morning the gate just won’t move, and there was no symptom until there was no gate.
- Post lean from Blackland Prairie clay. The expansive clay under Providence shrinks and swells with every wet-dry cycle, and the original builder-installed hinge posts, often set only 24 to 30 inches deep, get pushed out of plumb. A leaning post binds the swing geometry and kills boards and gear teeth long before their time.
- Missing or bypassed safety photocells. Pre-2016 installs in Providence frequently lack functioning photo-eyes or edge sensors, which is a UL 325 violation and a genuine entrapment hazard. We flag it honestly, and we fix it, because a gate that closes on a grandkid is not an acceptable risk.
- HOA mismatch after a DIY or low-bid repair. Providence’s HOA governs gate aesthetics closely, and off-brand panels or chrome hardware that doesn’t match the original powder-coated ornamental iron will get you a violation letter. We match the original finish and profile, including custom on-site welding where the original part is gone.
Pricing for Gate Access Control in Providence, TX
Here’s what Providence homeowners can expect to pay. A keypad replacement runs $180 to $340. A remote receiver or reprogram is $85 to $220. Card reader installation runs $300 to $650. Phone entry starts around $450 and goes to $950. Video intercom is the bigger ticket, at $800 to $1,600 for a full install. Smart modules add $250 to $400 to the base repair. Every price is quoted and agreed before we start, so the number on the invoice matches the number you approved. There’s no trip charge inside the county, $40 off any repair over $200, and a permanent 10% discount for seniors and veterans. Hal will give you a free second opinion on any written estimate, too. Call (979) 291-0947 and you’ll get a real number from a real person.
We Also Serve Cities Near Providence
Gatewood Fence & Gate covers Gate Access Control in Providence as well as Prosper, Plano, Allen, and Frisco. If you’re a few miles out, the same crew, the same promise, and the same live person on the phone. No trip charge inside the county.
Serving Providence, TX - Our Local Coverage Area
We’re based in the Providence area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Access Control in Providence
The rain itself isn’t the problem; it’s the clay under your hinge post. Providence sits on Blackland Prairie, and that expansive clay swells when wet and shrinks when dry, moving the post in and out of plumb. The original builders often set posts 24 to 30 inches deep, which is too shallow for this soil, so a few wet cycles push the post over and the gate starts binding. We dig the post out, pour a deeper footing, and reset it. If you only adjust the gate, you’ll be doing it again in six months. Call (979) 291-0947 for a straight answer on your specific gate.
Yes, in most cases. A 2004-era LiftMaster swing gate opener can almost always accept a video intercom, because the intercom ties into the operator’s open-command circuit rather than replacing the operator itself. We install the camera and door station at the gate, run or reuse low-voltage wiring, and connect it to your phone app. The board in the LiftMaster may need a relay module, but the opener doesn’t have to go. We’ll tell you honestly if your board is too far gone to bother with, but that’s rare just for intercom work.
We match the finish, profile, and hardware style to the original powder-coated ornamental iron or steel that Providence’s HOA approved. That means powder-coating to the original color code, sourcing hardware in the right finish, and welding on site when a bracket or hinge point needs to be rebuilt rather than bolted. We’ve done enough HOA-governed repairs here that we know what the board will flag before you do.
For a swing gate operator post in Blackland Prairie clay, plan on 36 to 42 inches of depth and a concrete footing that goes all the way down, with rebar tying the post to the footing. The original Providence installs were often 24 to 30 inches, which looks fine for a year or two and then starts leaning. If your gate has already leaned once, the fix is resetting the post deeper, not just straightening the gate leaf.
Yes, if it’s an automatic gate, it’s required to meet UL 325 entrapment protection standards, which means functioning photo-eyes, edge sensors, or an equivalent safety system. Many pre-2016 Providence installs lack these or had them bypassed by a previous repair. We’ll inspect it, tell you what’s missing, and bring it into compliance. It’s a safety issue, not paperwork.
Call Gatewood Fence & Gate for Gate Access Control in Providence
If your gate won’t open, your keypad is dead, or the HOA sent a letter about your gate hardware, call Hal. You’ll get a straight answer about what’s worth fixing and what’s not, a price you can hold us to, and a person who will show up when he says he will. Dial (979) 291-0947 any time, day or night, and a live person picks up. Free estimates, no trip charge inside the county, and the 90-Day Done Right Promise on every job.
Written by Hal Gatewood, Owner at Gatewood Fence & Gate, serving Providence for over two decades since 2001.